Install a 2001 Ford Taurus Valve Cover Gasket

The Ford Taurus engine uses two different methods to seal the valve cover to the engine head. Some models use a pre-cured reusable gasket, while other models use silicone sealant to form a bead of sealing material. On models that are equipped with plastic valve covers, either the silicone or gasket may be used; on models that have aluminum valve covers, silicone must be used. Use the type of gasket material that originally was used by the factory on your engine

Procedures:
1. Unhook the negative battery clamp; this is the one with the (-) on it.
2. Remove any hoses or wires that are on top of the valve cover. Label them so you can put them back in the right location.
3. Remove the valve cover bolts by using the wrench to turn them counterclockwise. Remove the valve cover from the engine. Scrape off any old gasket material with the scraper.
4. Install the new gasket or new silicone sealer and allow it to dry for a few minutes. Put the valve cover back on the engine.
5. Tighten the valve cover bolts by turning them clockwise with the wrench. Replace the wires and hoses. Connect the negative battery clamp and start the engine checking for leaks.